Filesystems

Alpine Linux supports a number of filesystems.

Filesystem Tools

Alpine has multiple storage media formatting packages available. Different packages/programs are used to format different types of filesystems.

Tool	Filesystem	Brief Notes
btrfs-progs	Btrfs
dosfstools	FAT12/FAT16/FAT32
e2fsprogs	ext2/ext3/ext4	ext4 is current default
f2fs-tools	F2FS
hfsprogs	XFS HFS/HFS+	Apple/Mac products
jfsutils	JFS
ntfs-3g	NTFS	Microsoft/Windows FUSE driver
xfsprogs	XFS

Swap Partition

Swap space is used for two purposes

1. Extend the virtual memory beyond the installed physical memory (RAM) to avoid Out of memory condition
2. Suspend-to-disk or Hibernation support

Below Instructions explain how to use a seperate partition for swap:

The following commands prepares the unmounted partition (/dev/sda2) for swap space, activates the prepared swap space and starts the swap service to manage swap space immediately:

# mkswap /dev/sda2
# swapon /dev/sda2 
# rc-service swap start

The command free -m will show how much swap space is available (in MB).

To make the swap persistent across reboots, enable automatic start of swap:

# echo -e "/dev/sda2 none swap sw 0 0" >> /mnt/etc/fstab
# rc-update add swap 

If you prefer maximum speed, you don't need configure any raid devices for swap. Just add 2 swap partitions on different disks and linux will stripe them automatically. The downside is that the moment one disk fails, the system will go down. For better reliability, put swap on RAID1.

Tip: Instead of using a separate partition for swap, zram based swap file can be used.

Encrypted swap

The below steps explains the steps to enable crypt-swap or Encrypted swap parition.

Edit the file /etc/conf.d/dmcrypt to enable crypt-swap. Ensure that source device name is correct. :

Contents of /etc/conf.d/dmcrypt

swap=crypt-swap source='/dev/nvme0nXXX'

To use dmcrypt, start dmcrypt service and enable swap immediately:

# /etc/init.d/dmcrypt start
# swapon /dev/mapper/crypt-swap

To make the encrypted swap persistent across reboots, enable automatic start of encryption & swap:

# rc-update add dmcrypt
# rc-update add swap

To enable automatic swapon, add the relevant entry to /etc/fstab

# echo /dev/mapper/crypt-swap swap swap defaults 0 0 >> /etc/fstab

Note: The above instructions will reset/re-encrypt swap on every boot and thus no suspend to disk works with it.

See Also

• How to enable encrypted swap in Alpine Linux