Talk:High performance SCST iSCSI Target on Linux software Raid

From Alpine Linux
Revision as of 18:21, 18 December 2012 by Nangel (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Thanks for the work; yes, please feel free to move this to a new section on the main page. --Nangel (talk) 18:21, 18 December 2012 (UTC)

Hello, I have read though this article and made my own iscsi storage device for vSphere. I also managed to get the Multipath working, together with using vmware's round-robin mpio.

The image below shows my configuration, using a home-made server with Raid 50, two switches and an off-load iSCSI NIC with two ethernet ports. The storage server runs an Redhat-Linux with the scst-iscsi daemon.


To configure mpio I have done the follwing steps:

  • configure routing on the storage server:
 route add eth1
 route add eth2
  • manually add the corresponding ip-address to the nic ( to vmhba34 and to vmhba33)
  • if I do ping-tests from the storage-server to the esxi-box, the packets come back from the expected interface
  • the statistics (eg ifconfig) of the two nics show about the same throughput, indicating the mpio is working fine.
  • I do not have any experience with vSphere 5
  • if you are using the software-iscis from ESXi, you may use two different subnets. I have not testet this, so it is mainly an idea.