Saving time with Hardware Clock: Difference between revisions

From Alpine Linux
m (Add page to Raspberry category as it's focusing on a Raspberry Pi)
Line 43: Line 43:


to /media/mmcblk0p1/config.txt
to /media/mmcblk0p1/config.txt
== Starting hwclock on boot ==
The hwclock service needs to be started for the hardware clock device to actually do anything. Check if hwclock has been started by running this command:
{{cmd|rc-status {{!}} grep hwclock}}
If it outputs
<pre> hwclock                                                          [  started  ]</pre>
hwclock has already started. Otherwise start it manually and add it to the default init.d runlevel, so that it starts at boot time:
{{cmd|sudo rc-service hwclock start}}
{{cmd|sudo rc-update add hwclock default}}
If you are running Alpine Linux in the diskless mode (non-persistent root filesystem), save the configuration by:
{{cmd|sudo lbu commit -d}}


[[Category:Hardware]]
[[Category:Hardware]]
[[Category:System Administration]]
[[Category:System Administration]]
[[Category:Raspberry]]
[[Category:Raspberry]]

Revision as of 14:45, 4 February 2023

Install Hardware

I used a PiFace Real Time Clock. After installing the CR1220 battery and correctly mounting on the board, see manual for that.

Install Software

Add the modules from the kernel

/etc/modules/

Add these modules so they're loaded on boot. You can modprobe each one individually if you don't want to reboot.

i2c_dev
i2c_bcm2708
i2c:mcp7941x

/media/mmcblk0p1/config.txt

You will need to mount this as read-write

mount -o remount,rw /media/mmcblk0p1

Add these two parameters to the bottom

dtparam=i2c1=on
dtparam=i2c_arm=on

mount -o remount,ro /media/mmcblk0p1

Then you will need to reboot.

Binding the hardware clock device

You will want to make sure the device is created when hwclock starts, if it isn't already created. To the bottom of /etc/conf.d/hwclock add this:

start_pre() {
    if [ -d "/sys/class/i2c-adapter/i2c-1/i2c-dev/i2c-1" ]; then
        einfo "Creating RTC device";
        echo mcp7941x 0x6f > /sys/class/i2c-adapter/i2c-1/new_device
    fi
}

For the time being this is necessary but in the future when issue 1032 you should be able to just add

dtparam=i2c-rtc,mcp7941x

to /media/mmcblk0p1/config.txt

Starting hwclock on boot

The hwclock service needs to be started for the hardware clock device to actually do anything. Check if hwclock has been started by running this command:

rc-status | grep hwclock

If it outputs

 hwclock                                                           [  started  ]

hwclock has already started. Otherwise start it manually and add it to the default init.d runlevel, so that it starts at boot time:

sudo rc-service hwclock start

sudo rc-update add hwclock default

If you are running Alpine Linux in the diskless mode (non-persistent root filesystem), save the configuration by:

sudo lbu commit -d