Bonding: Difference between revisions

From Alpine Linux
(→‎Installation: Add install command for 2nd example)
m (→‎Configuration: fix invalid closing pre)
Line 29: Line 29:
Bonding with br0 (LACP)
Bonding with br0 (LACP)
<pre>
<pre>
auto bond0
auto bond0
iface bond0 inet manual
iface bond0 inet manual
Line 41: Line 40:
         bridge-stp 0
         bridge-stp 0
                 hostname alpine
                 hostname alpine
<pre>
</pre>

Revision as of 11:10, 30 July 2022

This article shows how to bond (or aggregate) multiple ethernet interfaces into a bond0 interface.

Note: Alpine Linux v2.4 or later is required

Installation

First, install the bonding package. This will give you support for bonding in the /etc/network/interfaces file.

apk add bonding

And if you want to setup a LACP setup with a bridge interface you also need to install:

apk add bridge

Configuration

Edit the /etc/network/interfaces file:

auto bond0
iface bond0 inet static
	address 192.168.0.2
	netmask 255.255.255.0
	gateway 192.168.0.1
	# specify the ethernet interfaces that should be bonded
	bond-slaves eth0 eth1 eth2 eth3

The keyword is bond-slaves that will make ifup add the slaves to the bond0 interface.

References: http://www.kernel.org/doc/Documentation/networking/bonding.txt


Bonding with br0 (LACP)

auto bond0
iface bond0 inet manual
        bond-slaves eth0 eth1
        bond-mode 802.3ad
        bond-xmit-hash-policy layer2+3

auto br0
iface br0 inet dhcp
        bridge-ports bond0
        bridge-stp 0
                hostname alpine