Development using git:Creating patches

From Alpine Linux
Revision as of 16:43, 28 October 2018 by Brebs (talk | contribs) (Note that email functionality needs more than just the git package installed)

Patches should be created with git and submitted to alpine-aports mailing list with git send-email (which needs the git-email Alpine package).

Only the last commit with 'git send-email'

To submit the last commit as a patch to alpine-aports mailing list:

git send-email --to alpine-aports@lists.alpinelinux.org -1

Tip: You save the To-address (does not require '--to alpine-aports@lists.alpinelinux.org') in the git config with:

git config sendemail.to alpine-aports@lists.alpinelinux.org

The first line in commit message will be subject and the long description (separated with empty line) will be the body in the email. The example below shows

testing/packagename: new aport <- header

https://example.com/packagename <- body
wonderful package
Note: The git send-email command is provided by the git-email package (git-perl in v2.7 and older).

See Development using git#Email_configuration on how configure SMTP Auth.

Multiple commits with 'git send-email'

If you have many commits you can create a directory with patches and send them with git send-email.

rm -Rf patches mkdir patches git format-patch -o patches origin git send-email patches --compose --no-chain-reply-to --to alpine-aports@lists.alpinelinux.org

You can also format patches for the last x number of commits with:

git format-patch -x -o patches

This will produce the patches for each local commit in the directory "patches" and send them. Use --no-chain-reply-to to avoid that each patch is sent as a reply to the previous patch.

Eg.

  • [PATCH 0/m]
    • [PATCH 1/m]
      • [PATCH 2/m]
        • ...

With the option --no-chain-reply-to the patches will be sent as a reply to the first email, the cover letter (the [PATCH 0/m]) and will make the email thread nicer. Like this:

  • [PATCH 0/m]
    • [PATCH 1/m]
    • [PATCH 2/m]
    • ..

Resend an updated patch

Sometimes patches are rejected due to minor issues in the patch. Do not send an incremental patch on top of your initial, bad, patch. Instead, recreate the patch and send a new, fixed version of your patch. (use git commit --amend to edit a local commit).

When you sending a second version of the patch use --subject-prefix "PATCH v2" to indicate that this is a new version of a previously sent patch. You may also use --in-reply-to <message-id> where <message-id> the the id of email requesting the resend.

You should also write a note on the what was changed. Use --annotate for this and write the comment under the three dashes "---" so the note is not included in the commit message. For example:

...
Subject: [PATCH v2] testing/mypackage: new aport

https://example.com
Example package
---
Changes v1 -> v2:
 - removed depends
 - added zlib-dev to makedepends

 testing/mypackage/APKBUILD | 41 +++++++++++++++++++++++++++++++++++++++++
 1 file changed, 41 insertions(+)
 create mode 100644 testing/mypackage/APKBUILD
...

Note that the notes that are below the "---" will not be included in the commit message.

See also