Talk:Installation
About Installing Alpine on Compact Flash and Installing Alpine on USB, I think those two should be merged, steps are thesame. --K0gen 20:06, 25 February 2010 (UTC)
Booting from ISO
Current system is a 2.8 Prescott Pentium IV with 2MB RAM, booting from a 1GB CF plugged into the IDE controller, with an attached 500GB SATA HDD for data. When I tried to install Alpine from the LiveCD to this card, which is listed as a hard drive by the BIOS, it complained of insufficient space. Fair enough. Next I tried to follow this recipe to boot from Alpine 2.1.4 iso; at the end you find this tip:
- Adding an Unlisted ISO: To try ISO Files that are not yet listed, use the existing menuentry examples in /boot/grub/grub.cfg and append any options normally found in the distributions syslinux.cfg file on the "append" line to the "linux" line of the menu entry.
So I downloaded the latest Alpine iso via wget and modified the relevant grub.cfg lines to:
linux (loop)/boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet initrd (loop)/boot/grsec.gz
All I got when I tried to boot this was the following error:
Alpine Init 2.1.2
/init: eval: line 1: syntax error: unexpected "("
kernel panic - not syncing: attempted to kill init!
Pid: 1, comm: init Not tainted 2.6.35.10-grsec #1-Alpine
[...]
I must say all went well with the Linux Mint 10.10 and the TinyCore isos, into which I'm able to boot with no issues. Anyone care to advise?
Hi, that "linux (loop)/boot/...." thing looks funny to me.
According to: https://help.ubuntu.com/community/Grub2
Could you try:
set root=(loop0) linux /boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet initrd /boot/grsec.gz
Nangel 13:49, 6 February 2011 (UTC)
Hi & thanks, Nangel.
Tried that and got this error:
error: no such disk. error: you need to load the kernel first. press any key to continue...
Pressing any key returns to the grub menu. Maybe the full grub.cfg entry should be reported here:
menuentry "Alpine Linux" {
loopback loop /alpine214.iso
linux (loop)/boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet
initrd (loop)/boot/grsec.gz
}
It should also be noted that the LiveCD used to perform the recipe was "Linux Mint 9 LXDE", which caused Grub 1.98-1ubuntu5-1mint2 to be installed, not Grub2. And that (loop) part is present in every other successful menu entry.
Pnin 14:34, 6 February 2011 (UTC)