Btrfs

Documentation how to use Btrfs on Alpine Linux.

Install

Installing Btrfs is relatively straight forward. Install the package and tell Alpine to load the module on startup:

# apk add btrfs-progs # echo btrfs >> /etc/modules

To load the module right away, you can use the following command:

# modprobe btrfs

Mounting a volume

To mount a volume on boot, add a new entry to your fstab:

Contents of /etc/fstab

...
UUID=abcdef-0055-4958-990f-1413ed1186ec  /var/data  btrfs   defaults,nofail,subvol=@  0  0

If you use more specific mounting options like for example:

Contents of /etc/fstab

...
UUID=005f5994-f51c-4360-8c9b-589fa59ea6fc  /mnt/hddext  btrfs  nofail,rw,noatime,commit=64,nossd,autodefrag,compress=zstd:10  0 2

do not forget to install additional dependencies. If you enabled on the fly compression you need to install zstd:

# apk add zstd

More information about mounting can be found in the official Btrfs wiki

Troubleshooting

Mount failed

If you try mounting a Btrfs volume via your /etc/fstab and it doesn't show up, it could be because Btrfs does not know about the drives during boot.

To work around this, you can create an OpenRC service that runs a btrfs scan to detect the drives. To do so, create a new service under /etc/init.d/btrfs-scan with the following content:

Contents of /etc/init.d/btrfs-scan

#!/sbin/openrc-run

name="btrfs-scan"

depend() {
  before localmount
}

start() {
  /sbin/btrfs device scan
}

Make the service executable and register it:

# chmod +x /etc/init.d/btrfs-scan # rc-update add btrfs-scan boot

The volume should mount correctly after a reboot.

Install

Mounting a volume

Troubleshooting

Mount failed

See also