Talk:Installation

About Installing Alpine on Compact Flash and Installing Alpine on USB, I think those two should be merged, steps are thesame. --K0gen 20:06, 25 February 2010 (UTC)

Booting from ISO

Current system is a 2.8 Prescott Pentium IV with 2MB RAM, booting from a 1GB CF plugged into the IDE controller, with an attached 500GB SATA HDD for data. When I tried to install Alpine from the LiveCD to this card, which is listed as a hard drive by the BIOS, it complained of insufficient space. Fair enough. Next I tried to follow this recipe to boot from Alpine 2.1.4 iso; at the end you find this tip:

Adding an Unlisted ISO: To try ISO Files that are not yet listed, use the existing menuentry examples in /boot/grub/grub.cfg and append any options normally found in the distributions syslinux.cfg file on the "append" line to the "linux" line of the menu entry.

So I downloaded the latest Alpine iso via wget and modified the relevant grub.cfg lines to:

linux (loop)/boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet
initrd (loop)/boot/grsec.gz

All I got when I tried to boot this was the following error:

Alpine Init 2.1.2
/init: eval: line 1: syntax error: unexpected "("
kernel panic - not syncing: attempted to kill init!
Pid: 1, comm: init Not tainted 2.6.35.10-grsec #1-Alpine
[...]

I must say all went well with the Linux Mint 10.10 and the TinyCore isos, into which I'm able to boot with no issues. Anyone care to advise?

---

Hi, that "linux (loop)/boot/...." thing looks funny to me.

According to: https://help.ubuntu.com/community/Grub2

Could you try:

set root=(loop0)
linux /boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet
initrd /boot/grsec.gz

Nangel 13:49, 6 February 2011 (UTC)

---

Hi & thanks, Nangel.

Tried that and got error:

error: no such disk.
error: you need to load the kernel first.
press any key to continue...

Pressing any key returns to the grub menu. Maybe the full grub entry should be reported here:

menuentry "Alpine Linux" {
loopback loop /alpine214.iso
linux (loop)/boot/grsec initrd=/boot/grsec.gz iso-scan/filename=/alpine214.iso alpine_dev=usbdisk:vfat modules=loop,cramfs,sd-mod,usb-storage quiet
initrd (loop)/boot/grsec.gz
}

It should also be stated that the LiveCD used to perform the recipe is "Linux Mint 9 LXDE", which seems to have caused Grub 1.98 to be installed, not 2. And that (loop) part is present in every other successful menu entry.