Elogind

elogind is a login manager and provides support for

• setting up necessary permissions for the desktop environment or window manager
• handling poweroff, reboot, suspend and hibernate via loginctl command

Installation

# apk add elogind # rc-update add elogind # rc-service elogind start

Polkit is used for authentication. Without it some things may not function. You need to install and configure D-Bus to use polkit.

# apk add polkit-elogind # rc-update add polkit # rc-service polkit start

Set up a PAM login.

Hibernating

For

# loginctl hibernate

to work, you must have a swap partition. Check

# lsblk

for a partition with the mountpoint [SWAP].

NAME        MAJ:MIN RM   SIZE RO TYPE MOUNTPOINTS
nvme0n1     259:0    0 953.9G  0 disk 
├─nvme0n1p1 259:1    0   200M  0 part /boot
├─nvme0n1p2 259:2    0   100G  0 part /
├─nvme0n1p3 259:3    0   805G  0 part /home
└─nvme0n1p4 259:4    0  48.7G  0 part [SWAP]

Remember also to add a kernel parameter to resume, ie in /etc/default/grub :

Contents of /etc/default/grub

... GRUB_CMDLINE_LINUX_DEFAULT="modules=sd-mod,usb-storage,ext4,nvme quiet rootfstype=ext4 resume=/dev/nvme0n1p4"

Note the "resume=" flag with the same partition that was marked as [SWAP].

Configuration

logind.conf

Edit /etc/elogind/logind.conf to configure handling of power events, such as suspending the computer when power button is pressed:

Contents of /etc/elogind/logind.conf

... [Login] HandlePowerKey=suspend ...

Working with Desktop Environments

If using a Window Manager or Desktop Environment, such as Sway, the user must ensure that login session is correctly configured. When correctly configured, the loginctl command should output the following:

Using Sway and SDDM

~$ loginctl SESSION UID USER SEAT TTY c1 105 sddm seat0 c2 1000 User seat0 tty8 2 sessions listed.

If the output is No session available., such as in the case of launching Sway from tty, suspend and many other functionality will not work. The user then must configure a display manager such as greetd, SDDM or lightdm.

Doas

Doas is used to grant permissions for suspend-to-RAM and brightness control with brightnessctl:

apk add doas brightnessctl
# optionally, allow $USER root access with password
adduser $USER wheel

In /etc/doas.conf, set

permit :wheel
permit nopass $USER as root cmd /bin/loginctl
permit nopass $USER as root cmd /usr/bin/brightnessctl

After setting the above, suspend-to-RAM can be triggered by running

/bin/loginctl suspend

(use full path to executable) and brightness can be adjusted by running

/usr/bin/brightnessctl set 100

See also

• elogind - Gentoo Wiki
• polkit - Gentoo Wiki
• polkit - ArchWiki