AppArmor

AppArmor is a kernel security module that restricts individual programs' capabilities. This can allow administrators to prevent programs accessing system resources in malicious ways according to per-applications specifications. AppArmor works by following profiles, which dictate what each application is and is not allowed to do.

Installation

# apk add apparmor

You should also install apparmor-utils if you want to use the aa command to interact with AppArmor.

# apk add apparmor-utils

Setup

Run the command

# cat /sys/kernel/security/lsm

to see what linux security modules are currently setup.

With SYSLINUX

Use a text editor of your choice (preferably a TUI based one since some GUI setups don't work with privilege escalation, unless you use sudo -e) to edit

/boot/extlinux.conf

such that the APPEND line ends with the following:

lsm=landlock,yama,apparmor

Note that because you're including lsm in this .conf file you are overriding the default lsm. Thus, you should include any lsm that you saw previously running in the above cat command. Additionally, lsm initializes these modules in order, so their position is important in regards to major/minor modules. Ensure that apparmor is placed first among major modules. Note for convenience that yama, capability, and landlock, which come with Alpine Linux, are not major modules, and apparmor can be placed after them. The module called capability is automatically included and does not need to be written in.

With GRUB

Add the following at the end of the value for key GRUB_CMDLINE_LINUX_DEFAULT to /etc/default/grub:

apparmor=1 security=apparmor

Then apply with:

# grub-mkconfig -o /boot/grub/grub.cfg

Running

Next, start AppArmor and tell openrc to start it on boot.

# rc-service apparmor start

# rc-update add apparmor boot

You can check if AppArmor is running with the command aa-enabled

# aa-enabled

Configuration

AppArmor works using rules established in profiles. A set of pre-made profiles is available for ease of use:

# apk add apparmor-profiles

Reboot.

Additional profiles

The profiles provided by the apparmor-profiles package are just a starter. You can create your own profiles by running

# aa-easyprof <binary name>

or

# aa-genprof <binary name>

Note that for this to work you'll probably need to set a more verbose kernel log level.

Use

View AppArmor's report with the command aa-status

# aa-status

This details how many and what profiles are in use as well as relevant findings, such as how many profiles are in complain mode or in kill mode.

Troubleshoot

If you notice a bunch of AppArmor errors on boot, try running aa-status and aa-enabled in the terminal. If the output mentions AppArmor being disabled at boot, re-open your /boot/extlinux.conf file and make sure the APPEND line still ends with lsm=landlock,yama,apparmor