User:Innsill/dwm-starter (x86-64): Difference between revisions
No edit summary |
No edit summary |
||
| Line 17: | Line 17: | ||
* BOOTLOADER=grub </br> setup-disk /mnt | * BOOTLOADER=grub </br> setup-disk /mnt | ||
* {{c| mount /dev/ /mnt/dev/ --bind}} </br> {{c| mount -t proc none /mnt/proc}} </br> {{c| mount -o bind /sys /mnt/sys}} </br> chroot /mnt </br> grub-install /dev/sda | * {{c| mount /dev/ /mnt/dev/ --bind}} </br> {{c| mount -t proc none /mnt/proc}} </br> {{c| mount -o bind /sys /mnt/sys}} </br> chroot /mnt </br> grub-install /dev/sda | ||
= = | |||
* {{c| X -configure}} | |||
** {{c| vi xorg.conf.new}} | |||
Section "Device" | |||
Identifier "Card0" | |||
Driver "[[amdgpu]]" | |||
BusID "PCI:0:17:0" | |||
EndSection | |||
= = | = = | ||
Revision as of 09:32, 4 November 2019
... ???
alpine-extended-3.10.3-x86_64.iso
- lsblk
- wipefs /dev/nvme0n1
- __________________________________________________
fdisk /dev/nvme0n1- o - clear out any partitions
- n
- p - primary
1 - first partition on the drive
+16G
t - 82 Linux swap
...
- p - primary
- n
... enter - to accept the default ending sectors - ...
- __________________________________________________
fdisk /dev/sda- ...
a - toggle a bootable flag
...
- ...
- __________________________________________________
mkfs.btrfs -L RC100 /dev/nvme0n1p2
mkfs.ext3 -L OLD_HDD /dev/sda2
wipefs /dev/nvme0n1p2
wipefs /dev/sda2 - __________________________________________________
mount -t btrfs -o compress /dev/nvme0n1p2 /mnt
mkdir /mnt/boot
mount /dev/sda2 /mnt/boot - BOOTLOADER=grub
setup-disk /mnt mount /dev/ /mnt/dev/ --bind
mount -t proc none /mnt/proc
mount -o bind /sys /mnt/sys
chroot /mnt
grub-install /dev/sda
X -configurevi xorg.conf.new
Section "Device"
Identifier "Card0"
Driver "amdgpu"
BusID "PCI:0:17:0"
EndSection