Saving time with Hardware Clock

Install Hardware

I used a PiFace Real Time Clock. After installing the CR1220 battery and correctly mounting on the board, see manual for that.

Install Software

Add the modules from the kernel

/etc/modules

Add these modules so they're loaded on boot. You can modprobe each one individually if you don't want to reboot.

Contents of /etc/modules

i2c_dev i2c_bcm2708 i2c:mcp7941x

/media/mmcblk0p1/config.txt

You will need to mount this as read-write

mount -o remount,rw /media/mmcblk0p1

Add these two parameters to the bottom

Contents of /media/mmcblk0p1/config.txt

dtparam=i2c1=on dtparam=i2c_arm=on

mount -o remount,ro /media/mmcblk0p1

Then you will need to reboot.

Binding the hardware clock device

You will want to make sure the device is created when hwclock starts, if it isn't already created. To the bottom of /etc/conf.d/hwclock add this:

Contents of /etc/conf.d/hwclock

... start_pre() { if [ -d "/sys/class/i2c-adapter/i2c-1/i2c-dev/i2c-1" ]; then einfo "Creating RTC device"; echo mcp7941x 0x6f > /sys/class/i2c-adapter/i2c-1/new_device fi }

For the time being this is necessary but in the future when issue 1032 you should be able to just add

Contents of /media/mmcblk0p1/config.txt

... dtparam=i2c-rtc,mcp7941x

to /media/mmcblk0p1/config.txt

Starting hwclock on boot

The hwclock service needs to be started for the hardware clock device to actually do anything. Check if hwclock has been started by running this command:

rc-status | grep hwclock

If it outputs

 hwclock                                                           [  started  ]

hwclock has already started. Otherwise start it manually and add it to the default init.d runlevel, so that it starts at boot time:

rc-service hwclock start

rc-update add hwclock default

If you are running Alpine Linux in the diskless mode (non-persistent root filesystem), save the configuration by:

lbu commit -d