Xen Dom0 on USB or SD
This guide will show you how to perform a Xen Dom0 install on a USB or SD card, so you can have your Dom0 running from tmpfs. This has some benefits, but you will need a place to store your guests (virtual machines) and a syslog server to redirect the logs to.
The first step is to set up a basic usb or SD install, to do this boot from the Alpine install CD (minimal is fine) and follow one of the following guides: Installing_Alpine_on_USB or Installing_Alpine_on_Compact_Flash. Once you finished installing Alpine Linux on your device, boot from it and configure your newly installed system:
Note: you might have to edit /etc/apk/repositories and change the first line so it points to /media/usb/apks
# setup-alpine [...] # apk update
Now you that you have your system properly configured, it's time to install Xen:
# apk add xen
Now we have Xen installed, but we will need to modify the usb bootloader in order to load the Xen kernel. The first step is to remount /media/usb with write permissions:
# mount -o remount,rw /media/usb
Then, copy the Xen kernel and mboot.c32 to the usb boot partition:
# cp /boot/xen-4.1.gz /media/usb/boot/ # cp /boot/mboot.c32 /media/usb/boot/
Now we have all the necessary files to boot Xen from the usb, it's time to change the bootloader and add a Xen entry, to do so open /media/usb/syslinux.cfg with your favorite editor and add one of the following entries:
LABEL xen MENU LABEL Xen KERNEL /boot/mboot.c32 APPEND /boot/xen-4.1.gz --- /boot/grsec alpine_dev=UUID=XXXX-XXXX:vfat modules=loop,squashfs,sd-mod,usb-storage modules=loop,squashfs,sd-mod,usb-storage modloop=/boot/grsec.modloop.squashfs pax_nouderef --- /boot/grsec.gz
Serial console boot:
LABEL xen MENU LABEL Xen KERNEL /boot/mboot.c32 APPEND /boot/xen-4.1.gz com1=115200,8n1 console=com1 --- /boot/grsec alpine_dev=UUID=XXXX-XXXX:vfat modules=loop,squashfs,sd-mod,usb-storage modules=loop,squashfs,sd-mod,usb-storage modloop=/boot/grsec.modloop.squashfs pax_nouderef --- /boot/grsec.gz
Change the UUID to the correct one, and add the necessary modules for your system. It's also a good idea to check Xen Boot options and set dom0_mem, dom0_vcpus_pin and dom0_max_vcpus at least.
The next step is to load the necessary kernel modules for Xen, we will add them to /etc/modules, so they will be loaded automatically on boot:
# echo "xen_netback" >> /etc/modules # echo "xen_blkback" >> /etc/modules # echo "xen_gntdev" >> /etc/modules
The last step is to configure startup services, we will need udev and xencommons at least to be started on boot:
# rc-update add udev sysinit # rc-update add udev-postmount # rc-update add xencommons
If you need the xm toolstack, also add xend to startup services:
# rc-update add xend
Ok, now you have a fully functional Xen install, it's time to save your changes and boot into it.
# lbu commit # reboot
Also remember to configure at least one network bridge following the Howto_Configure_a_Network_Bridge guide.