Setting up lm sensors: Difference between revisions
m (minor layout changes) |
mNo edit summary |
||
| Line 5: | Line 5: | ||
Load the i2c-dev module: | Load the i2c-dev module: | ||
{{Cmd|<nowiki>echo i2c-dev >> /etc/modules | |||
modprobe i2c-dev</nowiki>}} | |||
'''Note:''' If you already know the name of the sensor module, you can modprobe it now, and skip the sensors-detect and perl install. | '''Note:''' If you already know the name of the sensor module, you can modprobe it now, and skip the sensors-detect and perl install. | ||
Revision as of 16:42, 1 July 2011
This document is a short note on how to set up lm_sensors in Alpine.
Install the neccessary packages. You will need perl to run the sensors-detect script.
apk_add lm_sensors perl
Load the i2c-dev module:
echo i2c-dev >> /etc/modules modprobe i2c-dev
Note: If you already know the name of the sensor module, you can modprobe it now, and skip the sensors-detect and perl install.
Run sensors detect:
sensors-detect
On the question to scan ISA bus and Super I/O sensors, select "no". Grsec will not allow you to access /proc/port. On all other questions select the default.
You will not need perl anymore. Remove it before you forget.
apk_delete perl
Make services start during next reboot.
rc_add -k lm_sensors sensord
Start services:
/etc/init.d/lm_sensors start && /etc/init.d/sensord start
Save config using
lbu commit
.