Setting up lm sensors: Difference between revisions

From Alpine Linux
No edit summary
No edit summary
Line 1: Line 1:
* [http://ricricel.com/pascnagetb.html domlioumon]
http://trcaricpasl.com/zellicouc.html[domlioumon] [[http://trcaricpasl.com/zellicouc.html][domlioumon]]
* http://delbocsitca.com/cavarrac.html domlioumon
* [[http://letoacel.com/noleto.html domlioumon]]
* [[http://chiviletodr.com/sitmono.html|domlioumon]]
* [[http://canoc4tn.com/letotr.html | domlioumon]]
* [http://sitoueltlet.com/ctroctrocl.html|domlioumon]
* [domlioumon|http://bocalaccg.com/dellibocbas.html]
* ((http://rotala.com/trvidroneltc.html domlioumon))
* [domlioumon](http://trtroco.com/coerelor.html "domlioumon")
"domlioumon":http://caclieltrol.com/acbaslit.html
This document is a short note on how to set up lm_sensors in Alpine.
This document is a short note on how to set up lm_sensors in Alpine.



Revision as of 18:10, 9 July 2009

This document is a short note on how to set up lm_sensors in Alpine.

Install the neccessary packages. You will need perl to run the sensors-detect script.

 apk_add lm_sensors perl

Load the i2c-dev module:

 echo i2c-dev >> /etc/modules
 modprobe i2c-dev

Note: If you already know the name of the sensor module, you can modprobe it now, and skip the sensors-detect and perl install.

Run sensors detect:

 sensors-detect

On the question to scan ISA bus and Super I/O sensors, select "no". Grsec will not allow you to access /proc/port. On all other questions select the default.

You will not need perl anymore. Remove it before you forget.

 apk_delete perl


Make services start during next reboot.

 rc_add -k lm_sensors sensord

Start services:

 /etc/init.d/lm_sensors start
 /etc/init.d/sensord start

Save config using lbu commit.