Install to disk

From Alpine Linux
Revision as of 19:08, 29 September 2011 by Jbilyk (talk | contribs) (add setup-disk information (it's a start, not perfect though))
Note: This document covers 2.x.x release, for 1.8.x and older please see Native Harddisk Install 1.6

Installation

Run setup-alpine to configure the keyboard, hostname and networking.

setup-alpine

If using Alpine Linux 2.2.3 or later

When prompted for disk to use, if you are installing to a single hard drive, enter the device name, then choose a sys style installation.

If you would like to setup a RAID 1 array with 2 disks in the computer, enter both device names at the prompt and choose a sys style installation.

You're done!

If using Alpine Linux 2.2.2 or earlier

Create partitions with fdisk.

fdisk /dev/sda

You should have 2 partitions: /dev/sda1 as "Linux" (type 83) and /dev/sda2 as "linux swap" (type 82). The /dev/sda1 must be bootable (command "a" within fdisk).

Install needed programs for the setup

apk add e2fsprogs syslinux mkinitfs

Create filesystem and swap

mkfs.ext4 /dev/sda1 mkswap /dev/sda2

Mount file-system

mount -t ext4 /dev/sda1 /mnt

Clone the current running config created by setup-alpine (hostname, networking root password)

lbu package - | tar -C /mnt -zx

Install base packages on harddisk

apk add --root=/mnt --initdb $(cat /etc/apk/world)

Append the / and swap to fstab:

echo -e "/dev/sda1 / ext4 defaults 1 1" >> /mnt/etc/fstab echo -e "/dev/sda2 none swap sw 0 0" >> /mnt/etc/fstab

Configure the boot loader, extlinux. We use the provided syslinux as base.

cp /media/cdrom/syslinux.cf /mnt/boot/extlinux.conf vi /mnt/boot/extlinux.conf

It should contain something like:

timeout 20
prompt 1
default grsec
label grsec
    kernel /boot/grsec
    append initrd=/boot/grsec.gz root=/dev/sda1 modules=ext4 quiet

Install the bootloader:

extlinux -i /mnt/boot

Install syslinux bootloader at the beginning of the MBR so its bootable (note that its sda and not sda1)

dd if=/usr/share/syslinux/mbr.bin of=/dev/sda

Unmount, remove cdrom, and reboot. (If you can't eject, just remove it manually as the machine reboots)

umount /mnt umount /.modloop eject reboot

After reboot, you should be able to log in as root with the password you created in setup-alpine.