Include:Upgrading to Edge: Difference between revisions

From Alpine Linux
(update)
(change it from 3.2 to digit.digit)
Line 3: Line 3:
To begin, you need to update your {{Path|/etc/apk/repositories}} file. Here are some shortcuts for doing so:
To begin, you need to update your {{Path|/etc/apk/repositories}} file. Here are some shortcuts for doing so:
:* Launch {{Cmd|setup-apkrepos}} Enter {{Key|e}} to edit {{Path|/etc/apk/repositories}}. Change the version number (such as <var>v3.2</var>) to '''edge'''.
:* Launch {{Cmd|setup-apkrepos}} Enter {{Key|e}} to edit {{Path|/etc/apk/repositories}}. Change the version number (such as <var>v3.2</var>) to '''edge'''.
:* Or, edit the file in place: {{Cmd|sed -i -e 's/<var>v3\.2</var>/<var>edge</var>/g' /etc/apk/repositories}}
:* Or, edit the file in place: {{Cmd|sed -i -e 's/<var>v[[:digit:]]\.[[:digit:]]</var>/<var>edge</var>/g' /etc/apk/repositories}}
   <!--  
   <!--  
   cat /etc/alpine-release | cut -c 0-3
   cat /etc/alpine-release | cut -c 0-3

Revision as of 20:30, 19 January 2018

An upgrade of Alpine Linux from a stable version to the rolling development version, edge can be done in a few simple steps. (These instructions assume that Alpine Linux is installed to a hard drive, rather than run-from-RAM.)

To begin, you need to update your /etc/apk/repositories file. Here are some shortcuts for doing so:

  • Launch

    setup-apkrepos

    Enter e to edit /etc/apk/repositories. Change the version number (such as v3.2) to edge.
  • Or, edit the file in place:

    sed -i -e 's/vdigit:\.digit:/edge/g' /etc/apk/repositories

The result should look like this:

Contents of /etc/apk/repositories

... http://dl-3.alpinelinux.org/alpine/edge/main


Next, upgrade all your packages in one shot:

apk upgrade --update-cache --available

The --available switch is used to force all packages to be upgraded, even if they have the same version numbers. Sometimes changes in musl-libc have required doing this.

Note: You will need to restart any services that have been upgraded to begin using the upgraded versions. If the kernel is upgraded, you will need to reboot to begin using the upgraded version:

sync reboot

To check your current release:

cat /etc/alpine-release

You will see the build date attached to the release.