Dropbox - Revision history

Bbbhltz: Added category: Storage

2023-04-17T11:19:09Z

Added category: Storage

← Older revision		Revision as of 11:19, 17 April 2023
Line 67:		Line 67:
	[https://rclone.org/dropbox/ rclone's Dropbox page], and of course, the		[https://rclone.org/dropbox/ rclone's Dropbox page], and of course, the
	man page for rclone.		man page for rclone.

			[[Category:Storage]]

Dennisc: sync writes local to remote, mount is more appropriate

2022-06-15T01:14:42Z

sync writes local to remote, mount is more appropriate

← Older revision		Revision as of 01:14, 15 June 2022
Line 54:		Line 54:
	Do this. If all went well, you should get a success message afterwards.		Do this. If all went well, you should get a success message afterwards.

	To ~~sync~~, run		To mount the remote filesystem, run
	<pre>		<pre>
	$ rclone ~~sync~~ ~/dropbox ~~dropbox:~~		$ rclone mount dropbox: ~/dropbox
	</pre>		</pre>
			(If ~/dropbox does not already exist, you need to make the directory.)

	As long as this command is running, your local and remote Dropbox		As long as this command is running, your local and remote Dropbox
	directories will be synced. If you want, you may set up a daemon to keep		directories will be synced. If you want, you may set up a daemon to keep

Psykose: init

2022-06-09T04:56:26Z

init

New page

[https://www.dropbox.com/ Dropbox] is a cloud-based file store
service.

= Syncing with rclone =

The official Dropbox client is fairly difficult to setup on Alpine. If
all you need is file syncing and you're fine with using a CLI to do it,
you can use [https://rclone.org/docs/ rclone].

Run
<pre>
# apk add rclone
</pre>
to install rclone.

Then run
<pre>
$ rclone config
</pre>
and you will be greeted with a series of interactive prompts.

First you start making a new remote.
<pre>
n) New remote
d) Delete remote
q) Quit config
e/n/d/q> n
</pre>

Then you need to give this new remote a name; it hardly matters what it
is, but for this guide we'll just call it "dropbox".
<pre>
name> dropbox
</pre>

Then you will be asked what kind of storage you want to use. Look for
the option that says "Dropbox" (as of the time of writing, it is 12),
and input that.
<pre>
Option Storage.
Type of storage to configure.
Choose a number from below, or type in your own value.
...
Storage> 12
</pre>

Then you will be asked about "OAuth Client Id" and "OAuth Client
Secret". Just leave those blank by pressing Enter as rclone instructs.
You'll be asked if you wanted to edit the advanced config and use auto
config too. Just press Enter to use the defaults, unless you have a
reason not to.

Finally, you will be prompted to allow rclone OAuth access to Dropbox.
Do this. If all went well, you should get a success message afterwards.

To sync, run
<pre>
$ rclone sync ~/dropbox dropbox:
</pre>
As long as this command is running, your local and remote Dropbox
directories will be synced. If you want, you may set up a daemon to keep
this persistently running.

More detailed usage instructions are also available at
[https://rclone.org/dropbox/ rclone's Dropbox page], and of course, the
man page for rclone.